[Linux-wlan-ng-devel] Bug#583522: CTLX[1] error: state(Request failed)

jidanni at jidanni.org jidanni at jidanni.org
Thu Jun 3 01:14:06 UTC 2010


OK, I suppose the ID is right, but odd, when I plug it in I get
"invalid interface number" messages, no matter what port I plug it into.

new full speed USB device using ehci_hcd and address 5
config 1 has an invalid interface number: 1 but max is 0
config 1 has no interface number 0 
New USB device found, idVendor=09aa, idProduct=3642
New USB device strings: Mfr=0, Product=0, SerialNumber=1
SerialNumber: 01190006
configuration #1 chosen from 1 choice

And then I have to modprobe by hand
# modprobe prism2_usb
prism2_usb: module is from the staging directory, the quality is unknown, you have been warned.
prism2_usb: Checking for firmware prism2_ru.fw
usb 1-3.1: firmware: requesting prism2_ru.fw
prism2_usb: prism2_ru.fw will be processed, size 90662
CTLX[1] error: state(Request failed)
CTLX[1] error: state(Request failed)
cmd_initialize() failed on two attempts, results -5 and -5
hfa384x_drvr_start() failed,result=-5
PDA may only be read in the fwload state.
load_cardpda failed, exiting.

TV> Make sure that you do "modprobe -r prism2_usb" first to remove it
TV> before loading it again, and that you try disable/enable just after
TV> the modprobe (do not run ifconfig). Please attach the full dmesg
TV> output afterwards.

# wlanctl-ng wlan0 lnxreq_ifstate ifstate=enable
CTLX[1] error: state(Request failed)
message=lnxreq_ifstate
  ifstate=enable
  resultcode=implementation_failure
CTLX[1] error: state(Request failed)
cmd_initialize() failed on two attempts, results -5 and -5
hfa384x_drvr_start() failed,result=-5






More information about the Linux-wlan-ng-devel mailing list