[Gnuk-users] [PATCH] Add board config for "Blue Pill"
NdK
ndk.clanbo at gmail.com
Fri Jan 13 16:46:14 UTC 2017
Il 12/01/2017 12:37, Paul Fertser ha scritto:
> I think in certain aspect it's even better than FST-01 if you solder a
> small USB wire directly to the board since I'm always afraid of
> damaging the port or the device itself in a typical "dongle"
> form-factor when it's sticking out.
For me it's more interesting to be able to experiment freely, adding a
display and some pushbuttons. Too bad the protocol does not pass what
could be needed to "validate" the signature.
>> Might it even be possible to run GnuK (or neug) on an stm32f030f4p6 ?
> No USB, 16K flash, 48MHz core? I'd say unlikely ;)
Urgh. You're right. The USB connector fooled me in thinking it was
supported, but it's there only as power connector.
BYtE,
Diego
More information about the gnuk-users
mailing list